Table of Contents
Advertisement
O
PERATION
Controller Parameters
Home Display
°C: measured temperature in Celsius. Temperature units
can not be changed without entering the configuration.
Contact Customer Service if a different temperature unit is
required.
OP: % output power demand; displayed in lower display
(cannot be changed).
C.id: Controller identification number.
PrG: Program number (displayed when a program is run-
ning.
IdHi: Deviation High Alarm
tunE: One-shot autotune enable.
run LiSt (Program Run List)
PrG: Currently running program (only used on multi-pro-
gram models)
StAt: Displays the program status [OFF, run (running
active program), hoLd (program on hold), HbAc (waiting for
process to catch up), End (program completed)] in the
lower display. The controller will default to "OFF."
PSP: Programmer setpoint temperature (displayed when a
program is running).
CYC: Number of cycles remaining in program (displayed
when a program is running).
SEG: Active segment number (displayed when a program
is running).
StYP: Active segment type (displayed when a program is
running).
SEG.t: Remaining segment time in segment units (dis-
played when a program is running).
tGt: Target setpoint.
rAtE: Ramp rate (only if rate segment).
PrG.t: Program time remaining in hours (displayed when a
program is running).
17
Advertisement
Table of Contents
