To View Or Change The Setpoint; To View The Display Units; To View The % Output Power; Controller Parameters - Barnstead 30400 Operation Manual

S S M
INGLE ETPOINT
14
/OTP
ODELS W

To View or Change the Setpoint

To view the setpoint, press and release the UP or DOWN
buttons. If you want to change the setpoint, continue press-
ing until the desired setpoint value is displayed and then
release the button. A few seconds after the button is
released, the controller will accept the new value and revert
to the HOME DISPLAY.

To View the Display Units

From the HOME DISPLAY press the SCROLL button. The
display will show the temperature units in °C/F/K and then
return to the HOME DISPLAY. (Call Customer Service if you
require a different temperature unit.)

To View the % Output Power

From the HOME DISPLAY press the SCROLL button twice.
Press and release the UP or DOWN button to view the %
output power. This value is a read-only value and cannot be
changed.

Controller Parameters

Home display
°C: Temperature units in Celsius. Temperature units can not
be changed without entering the configuration. Contact
Customer Service if a different temperature unit is required.
OP: % output power demand.
IdHi: Deviation high alarm.
Al List
IdHi: Deviation high alarm.
Atun List
tunE: One-shot autotune enable.