Table of Contents
Advertisement
Figure 1A: Element Replacement
M
(if not, reposition element ceramic holder).
Carefully wrap the connector cable around
the element ends; fasten with clips. Replace
top cover.
To replace thermocouple:
1.
Remove top cover from the heating cham-
ber side of furnace.
2.
Loosen diagonal screw holding ceramic con-
nection block.
3.
Lift connection block.
4.
Loosen connection block screws holding
thermocouple; noting which side of block the
side of the thermocouple with the colored
bead is connected to.
5.
Remove thermocouple.
6.
Install new thermocouple with colored bead
in same position.
7.
With thermocouple through the hole in the
insulation, replace block in its holder and re-
tighten diagonal screw.
8.
Turn furnace ON for a few minutes; check to
be sure the temperature displays upscale.
9.
Replace cover.
S
AINTENANCE AND
ERVICING
37
Advertisement
Table of Contents
