Barnstead F46110CM Operation Manual And Parts List page 19

O
PERATION
used with tYPE include; tGt target setpoint), Rate (rate of
temperature increase) and dur (time to target setpoint or
time to dwell).
End.t: End of program.
AL LiSt (Alarm List)
IdHi: Deviation High Alarm.
Atun LiSt: (Autotune List)
tunE: One-shot autotune enable.
drA: Adaptive tune enable.
drA.t: Adaptive tune trigger level in display units. Range =
1 to 9999.
Pid LiSt
G.SP (Gain Setpoint): If gain scheduling has been
enabled this parameter sets the PV (process value) below
which Pid1 (proportional band/integral time/derivative time)
is active and above which Pid2 is active.
Pb: Proportional band in display units. (SEt 1)
ti: Integral time in seconds. (SEt 1)
td: Derivative time in seconds. (SEt 2)
Pb2: Proportional band. (SEt 2)
ti2: Integral time in seconds. (SEt 2)
td2: Derivative time in seconds. (SEt 2)
SP LiSt (Setpoint List)
SP 1: Setpoint one value.
cmS LiSt (Comms List)
Addr: Communications address.
ACCS LiSt (Access List)
codE: Access password. Not needed for
normal operation. Call Customer Service if configuration is
required.
19