Table of Contents
Advertisement
O
PERATION
Note
The program ramp rate is designed to
reduce the heatup rate or cooling rate
that the furnace normally exhibits.
When not using this feature, the fur-
nace will operate at its maximum
heating and cooling capability.
Note
When the program ramp has ended or
has been reset, the furnace will contin-
ue to maintain setpoint temperature. It
will not cool to ambient temperature
unless setpoint is set to ambient tem-
perature by the program or by the
operator.
24
Setting the Number of Cycles
Set the number of times a group of segments or pro-
grams are to be repeated by following the steps listed
below.
1.
Press the PAGE button until you reach the pro-
gram list (ProG LiSt).
2.
Press the SCROLL button until display
reads,"CYC.n."
3.
Press the UP or DOWN button to select the
number of cycles you want to run; or, press the
DOWN button to select "cont." so the program
will run continuously.
Setting the Segment Number
A program is set up by defining the characteristics of each
individually selected number. To select a program num-
ber, follow the steps listed below.
1.
Press the PAGE button until you reach the pro-
gram list (ProG LiSt).
2.
Press the SCROLL button until display reads,
"SEG.n."
3.
Press the UP or DOWN button to select the
segment number.
Setting the Segment Type
There are five segment types. Proceed with the following
steps according to the type of segment you have select-
ed.
rmP.r (Ramp)
To ramp linearly at at set rate to a specified temperature:
1.
Press the PAGE button until you reach the pro-
gram list (ProG LiSt).
2.
Press the SCROLL button until display
reads,"tYPE."
3.
Press the UP or DOWN button until display
reads, "rmP.r."
Advertisement
Table of Contents
