Cpm-200 Ip Address Settings - Max Bepop CPM-200G Operation Manual

CPM-200 IP Address Settings
It is possible to connect the CPM-200 to a wireless Local Area Network(LAN).
IP Address Settings for the printer must be changed when using a LAN connection.
Cautions for connecting to a Local Area Network
Consult with your network administrator before
performing a LAN installation on your computer.
■ Message for system administrator
It is possible to connect the CPM-200 to your LAN.
Please follow the instructions below.
● The default IP Address for this printer is detailed
below.
Details
IP Address
Sub Network Mask
Default Gateway
* The following IP Addresses cannot be used:
①
0.0.0.0 (All 0)
②
255.255.255.255 (All 255)
③
127.xxx.xxx.xxx (Loopback address types)
④
xxx.xxx.xxx.255 (Subnet Broadcasts)
● To change the settings on the Printer please refer
to "Setting the Printer IP Address".
● To install and use the driver, it is necessary to log
in as an administrator.
● Restart computer after installing the driver.
In the event that multiple users are logged in, it will
be necessary for them to log-off before starting the
installation.
Default Setting
192.168.11.1
255.255.255.0
192.168.0.1
Page 21
● DHCP retrieval and SNMP management are not
supported.
● A single printer cannot be simultaneously
installed as both a USB port printer and a LAN
printer.
BepopPC EX Software Installation
20