The supplementary manual of LM-550A2 series
1.
Install a new ribbon to the ribbon case
1. Holding the "Winding core", pull the "Ribbon core"
lightly so that the adhered portion comes off.
When pulling the "Ribbon core",
let the core turn so that the ribbon is not gone slack.
2. While pressing "Button B," set the ribbon core
(green or blue) as shown in the figure.
Then, release the "Button B" to lock the ribbon.
Do not push too deep or too hard on the Button B.
Pay attention to the top and bottom of ribbon case.
3. While pressing "Button A," set the winding core (black)
as shown in the figure.
Then, release "Button A" to lock the ribbon.
Do not push too deep or too hard on the Button A.
4. Rotate the ink ribbon toward the direction of the arrow until the black surface appears.
(The color changes in the order of transparent → blue → black)
When the surface (black) has appeared, stop rotating.
Make sure the ribbon is not slack.
How to load consumables
1. Open the cassette cover.
.
Ink ribbon
Hold the ink ribbon case
as illustrated below and
load it completely.
Push the lever
1
Insert
Insert
The color changes.
2. Push the head release lever (blue) until it stops.
Proper loading
Press it lightly,
to check it is
set completely.
Press
Button B
Press
Button A
Rotation