Pole Hanger Replacement - SafeGait SG360 Service Manual

4 Pole Hanger Clamp:
DANGER: Power system down and lock out power panel prior to working on
conductor bars or clips. Failure to comply may result in injury or death!
1. Using condutix conductor bar removal tool loosen conductor bars from clip
2. Loosen two M4x6 and slide clip out of rail
3. Replace clip and tighten M4x6 with M3 Allen key
4. Replace conductor bars.
WARNING: Arc flash is possible during power-up after service if the conductor
shoes are not installed in the correct conductor bars.
82
SG360-ISM-004 | REV F