SafeGait SG360 Service Manual page 55

□
When read script finishes successfully close the window
□
Power off the actuator HMI and remove the compact flash card from it.
□
Replace CF with updated CF card or Preform the Create CF card steps
Create CF Card
□
Place the card in the compact flash card reader located in/with the tool laptop.
□
Run the script: Create_CF.bat. This will format the card and install the new software.
□
Alternatively, use a pre-programmed CF card with V3.0.0 already loaded.
□
Replace the card in the HMI, and power on the actuator.
Write CF card values
□
Open folder Configuration Values
□
Run the script: Config_Param.bat (read calibration and run time values)
54
SG360-ISM-004 | REV F