Pcmcia: Pc Card Slot; Vga Display Connector - Advantech Celeron M Universal Network Controller with PC/104 Extension UNO-2170 User Manual

Celeron m universal network controller with pc/104 extension

Hide thumbs Also See for Celeron M Universal Network Controller with PC/104 Extension UNO-2170:

Table of Contents

2.8 PCMCIA: PC Card Slot

The UNO-2170 provides one PC Card slot that supports CardBus (Card-

32) cards and 16-bit (PCMCIA 2.1/JEIDA 4.2) card standards. It supports

+3.3 V, +5 V and +12 V @ 120 mA working voltage. The PC Card is

85.6 mm long by 54 mm wide (3.37" x 2.126"), use a 68-pin connector

and a removable module standardized by PCMCIA that is known as

"PCMCIA card＂.

PS: PCMCIA interrupt assignment is IRQ 9.

The UNO-2170 provides a VGA controller (Intel 855/852 GME, supports a

single 1.5V accelerated graphics port interface) for a high resolution VGA

interface. It supports CRT Mode: 1280 x 1024 @ 32bpp (60Hz), 1024 x 768

@ 32bpp (85Hz); LCD/Simultaneous Modes: 1280 x 1024 @ 16bpp(60Hz),

1024 x 768 @16bpp(60Hz) and up to 32 MB shared memory.

The VGA interface is reserved for system testing and debugging. The

UNO-2170's JP8 is a 6-pin mini connector and CN7 is a 15-pin connector for

a VGA monitor. A VGA cable is attached to convert from a 6-pin mini

connector to standard VGA connector. You can choose one of the VGA

interfaces for system testing and debugging. Pin assignments for the VGA

display are detailed in Appendix A.9.

UNO-2170 User Manual

Table of Contents

Do you have a question about the Celeron M Universal Network Controller with PC/104 Extension UNO-2170 and is the answer not in the manual?