Table of Contents
Advertisement
4.
To change a value, press and release the Control button that relates to the desired value.
The LEDs for the selected buttons blink and the other LEDs remain lit.
Troubleshooting
The following are recommendations for actions to take if you have problems operating the
switcher:
1.
2.
3.
4.
5.
6.
Configuration Worksheets
Instead of trying to remember the configuration for each preset, use worksheets to record
this information. Make copies of the
for each preset configuration. Cross out all unused or inactive inputs and outputs. The
worksheet is generic for all models of DXP. Disregard or cross out boxes for inputs and
outputs that your switcher does not have.
The selected Control button LED blinks.
Press and hold simultaneously.
PRESET
ENTER
ESC
Figure 28.
RS-232 Baud Rate Display
Press and release an output button to exit the Serial Port Configuration mode.
Ensure that all devices are plugged in and powered on. The switcher is receiving power
if the Reset/Power LED is lit.
Check to see if one or more outputs are muted.
Ensure that an active input is selected for output on the switcher.
Ensure that the proper signal format is supplied.
Check the cabling and make corrections as necessary.
Extron S3 Sales & Technical Support Hotline
Call the
ENTER
PRESET
2 seconds
All Control LEDs light with one blinking.
if necessary.
blank worksheet
on page 34, and use one sheet
DXP HD 4K PLUS Series • Operation
ESC
31
Advertisement
Table of Contents
