Resetting; Resetting The System From The Front Panel - Extron electronics DXP 44 4K PLUS User Manual

NOTE: While the DXP is in this mode, you cannot create ties, mute an output, set

Resetting

There are several methods by which you can reset the DXP, and some of these methods
allow for four levels of resetting. The following reset methods are available on the DXP:
•
•
•
•

Resetting the System from the Front Panel

A system reset (also known as a "hard reset") does the following:
•
•
NOTE: The system reset does not reset the internet protocol (IP) settings, replace
The front panel reset is identical to the E
commands).
To reset the switcher to the factory default settings (see
1.
2.
the RS-232 baud rate, or save or recall a preset. Before attempting any of these
procedures, ensure that the unit is not in power save mode 2 (the Video LED for the
button blinks green continuously and no other front panel buttons respond).
I/O
Front panel buttons (see
Rear panel Reset button (see
the next page)
SIS commands (see the Reset Mode commands
Table for SIS Commands, page 51)
PCS (see the program help file)
Clears all ties and presets.
Clears all video and audio setup and mutes.
user-installed firmware, or reset the unit name to the factory default.
Disconnect power from the DXP, then immediately reconnect it. All front panel LEDs
blink four times, then turn off, leaving the I/O LEDs lit red.
Immediately press and continue to hold the
the following:
a. The Input Signal and HDCP LEDs blink in order in a clockwise, circling pattern.
b. All front panel LEDs blink three times, then turn off.
c. The I/O Video LED lights green.
Resetting the System from the Front
Resetting Using the Rear Panel Reset Button
in the Command and Response
} SIS command (see the
ZXXX
figure 26
button while the front panel LEDs do
I/O
DXP HD 4K PLUS Series • Operation
Panel)
on
Reset mode
on the next page):
27