Hmi Operation Levels; User Level; Menu Groups Of The User Level - ABB REM 610 Operator's Manual

1MRS755538
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 4.1.11.-1 Selecting the communication protocol for the rear connection
4.2.
4.2.1.
4.2.1.1.
Motor Protection Relay
Operator's Manual - ANSI version
The selected protocol is stored in the non-volatile memory and is therefore activated
automatically after an interruption in the auxiliary voltage.
Select the rear communication protocol as follows:
1. Press an arrow button to access the main menu.
2. Use the arrow buttons to select CONFIGURATION\COMMUNICATION\REAR
PROTOCOL and press
example SPA).
3. Press to enter the setting mode. The second line starts to flash.
4. Use or
5. Press to confirm the selection.
6. Press to return the display to the idle mode.
Group Menu
CONFIGURATION
FUNCTION TEST/DI
COMMUNICATION
LANGUAGE
MEMORY SETTINGS
FREQUENCY
HMI PASSWORDS
TIME
TRIP CIRCUIT SUP
RTD INPUTS
STORE COUNTER

HMI operation levels

The HMI menu consists of a user level and a technical level. The user level is used
for measuring and monitoring. The technical level is used for advanced protection
relay setting and can be configured to require a password. The password is required
after the default value 999 is replaced.

User level

Menu groups of the user level

The user level contains the following menu groups. You can monitor the data
without a password.
. The cursor is at the setting currently in use (for
to select the wanted setting.
Parameter Menu
CONFIGURATION
REAR CONNECTION
REAR PROTOCOL
REAR COM. MODULE
SPA SETTINGS
IEC103 SETTINGS
MODBUS SETTINGS
UNIT ADDRESS :xxx
COUNTER :xxx
LINE-IDLE STATE
CONNECTION TYPE
CONFIGURATION
SPA
Confirm
IEC 60870-5-103
MODBUS RTU
Cancel
MODBUS ASCII
REM 610 REM 610
A040245_2
25