Technical Level; Menu System Of Parameters; How To Change Settings - ABB REM 610 Operator's Manual

REM 610 REM 610
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 4.2.1.4.-1 INFO menu group
1) Relay serial number
2) CPU module software number and revision
3) CPU module serial number
4) CPU module software build number
5) Communication module software number and revision
6) Communication module serial number
7) Communication module software build number
4.2.2.
4.2.2.1.
4.2.2.2.
30
Motor Protection Relay
Operator's Manual - ANSI version
Parameter Menus
1
INFO
REM 610
xxxxxxxx
YYYYMMDD
CPU MODULE
RTD MODULE

Technical level

Menu system of parameters

Press an arrow button to activate the main menu. If the default password is in use,
no password is required to change the parameters. If the password protection is in
use, "***" is shown on the display until you give the valid HMI password.
The views are used for reading and setting parameters, which are divided into two
main groups:
SETTINGS
*
CONFIGURATION
*

How to change settings

The actual settings consist of the settings of group 1 or group 2, depending on which
group has been selected to be active (indicated by an asterisk "*"). The actual
settings can be seen in the first parameter menu, for example:
2 3 4
INFO
INFO
1MRS118511 A
xxx
xxxxxxxx
INFO INFO
xxx
1MRS118514 A
xxxxxxxx
5 6 7
1MRS755538
Cancel
A040252_2