Display Modes - ABB REM 610 Operator's Manual

1MRS755538
4.1.3.2.
Motor Protection Relay
Operator's Manual - ANSI version
1. The backlight is turned on after the relay has performed the internal power-up
tests and entered into the protection mode.
2. The display is tested by inverting it for approximately three seconds, see
Fig. 4.1.3.1.-1. In case a restart disable target is displayed, the display test will
not be run at power up.
3. The display is returned to the idle mode and the backlight is turned off if no
operation target message is displayed. However, if the non-volatile function is
active, a message shown on the display before the auxiliary voltage was
disconnected reappears on the display.
Fig. 4.1.3.1.-1 Display test at power up, display inverted

Display modes

When the display is in the idle mode, the name of the motor drive is displayed,
which by default is - ABB -. To change the name of the motor drive, use SPA
parameter M20.
- ABB
Fig. 4.1.3.2.-1 Display in the idle mode
When the display is in the view mode, you can only view the settings.
SETTINGS
*GRP1
Fig. 4.1.3.2.-2 Display in the view mode
When the display is in the setting mode, you can also edit the settings.
SETTINGS
*GRP1
Fig. 4.1.3.2.-3 Display in the setting mode
-
: 3.50
: 3.5 1
REM 610 REM 610
A040216
A040217
A040218
A040219
17