4) Assembly of position detector
(1) When the servo motor is installed
Connect it to the portable synchro pulley shaft. Use the
synchro fixing bar and the tightening screw
prevent the portable synchro from moving left or right.
When the synchro is fixed, use the socket set bolt ① to
fix it to the pulley shaft.
(2) When the clutch motor is installed
The portable synchro is not needed.
5) How to install the knee lifter
The knee lifter replaces manual operation of the presser
foot.To install, assemble the knee lifter units as shown in
Figure 5. Then fix it onto the backside of the table with three
wooden screws.
6) When the unit box is installed
– Needed when the servo motor is installed.
Fix the unit box bracket to the arm using the socket set
screw①. Place the unit box wiring inside. Fix the unit
box using the connecting bolt②.
12
② to
②
①
①
②
[Figure 4]
[Figure 5]
Unit box
bracket
Unit box
[Figure 6]