Tech Controllers ST-292 User Manual page 18

Heating/cooling mode
This function enables the user to select the room
regulator operation mode:
- controlling the cooling system
- controlling the heating system
Press or to select desired type of system.
Press MENU to confirm and move on to edit
another parameter in the service menu or press EXIT to confirm to return to the main screen
view.
WARNING
DO NOT select cooling system control if a floor sensor is used as it may damage the
underfloor heating system.
Channel selection (option available only in ST-292v2 and ST-292v4)
ST-292v2 and ST-292v4 communicates with the heating device or the CH boiler controller via a
receiver using a radio signal. For the communication to take place it is necessary to select the
same channel in both the controller and the receiver (and also in the external sensor if it is used).
Channel "35" is the default communication channel
in all devices. The channel should be changed only
if the current channel is used by other devices.
In order to change, go to service menu and press
MENU until the channel change panel appears on
the screen. Use
Press MENU to confirm and move on to the next
parameter or EXIT to confirm and return to the
main screen view.
Zone selection (option available only in ST-292v4)
Assigning ST-292v4 room regulator to a selected
zone is necessary to ensure its proper cooperation
with the external controller (e.g. ST-266, ST-268).
To configure this parameter go to service menu and
press MENU until the zone selection panel appears
on the screen.
Use or to select the zone number. Press
MENU to confirm and move on to the next
parameter or press EXIT to confirm and return to
the main screen view.
or to select the channel.
18
TECH