HP StorageWorks ESL E-Series User Manual page 121

Sense
ASC ASCQ
key
B 30 00
B 00
43
B 47 00
B 48 00
B 80 01
B
80 06
B 80 10
B 80 0B
B 80 0D
B 88 C0
B 8C 01
Message name / description
INCOMPATIBLE MEDIA
An attempt was made to move media to a destination element that is
incapable of receiving it. Make sure you are using the correct media
and that it is labeled with the correct barcode.
SCSI MESSAGE ERROR
Detected message error in message processing on the SCSI BUS.
• Verify termination.
• Verify SCSI cable connections.
• Check host status.
• Restart system.
SCSI PARITY ERROR
SCSI Parity Error detected.
• Verify termination.
• Verify SCSI cable connections and cable length.
• Check host status.
• Restart the system.
INITIATOR DETECTED ERROR MESSAGE RECEIVED
TRANSFER FULL - AT END OF PLACE
Picker has cartridge in it at end of a place operation (Move Medium
with a target other than the Transfer).
• Move cartridge to empty storage element using your application
software. Retry command.
• As a last resort, manually remove the tape from the robotics.
TRANSFER EMPTY - COMMAND ABORTED
Picker does not contain cartridge at end of pick portion of the Move
Medium command.
LOAD RETRY FAILED
Library was unable to successfully load and thread the drive, even after
retries.
• Check drive alignment.
• Make sure the correct media for the drive is being used.
• If cartridge loads in another drive successfully, the original drive
may have failed.
COMMAND ABORTED BY USER
Informational message. No action is necessary.
CARTRIDGE PARTIALLY GRIPPED
• Issue a Move Medium command using your application software to
move the cartridge from the transfer element to an empty storage
element.
• If necessary, manually clear the media, recalibrate, then inventory
the library.
TRANSPORT FULL
The CLM contains a cartridge. Issue a command to retrieve the cartridge
from the CLM and place it in either a bin or a tape drive.
LOAD PORT LATCH FAILURE
The load port door was unlocked, but did not leave its current position
before time-out (30 seconds). This may be due to the door being stuck,
or in the case of a close operation, the operator not moving the door.
121
HP StorageWorks