HP StorageWorks ESL E-Series User Manual page 115

Sense
ASC ASCQ
key
See
4 84 Table
22
See
4 85 Table
22
See
4 87 Table
22
4 88 00
4 88 01
4 89 00–FF
4 8A 02
See
4 8B Table
22
4 8C 06
4 8E 02
4 8E 03
4 8E 04
F2 00
4
Message name / description
VERTICAL HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
HORIZONTAL HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
DEPTH HARDWARE FAILURE
• Remove any obstructions.
• Run the Robotics Self Test from the OCP.
WARNING SAFE TEMPERATURE EXCEEDED
This is a warning that the temperature in the library exceeds the normal
operational temperature 40
MAXIMUM TEMPERATURE EXCEEDED
The robot in the overheated cabinet turns off and remains off until the
temperature returns to an acceptable level. For LTO, the acceptable level
is 52 o C (127 o F); for SDLT, the acceptable level is 49
• Check whether the air filters need to be replaced.
• Check for fan failure.
• Lower the ambient temperature.
VISION HARDWARE FAILURE
Vision internal failure.
CALIBRATION FAILURE
Check slots, cartridges, targets, and all internal elements. Verify that the
panels are properly seated and that doors are closed.
CLM HARDWARE FAILURE
CLM failure.
LOAD PORT DOOR OPEN
Load port door unlocked but failed to open.
SCSI UPGRADE TRANSFER FAILED
A data transfer error or a data storage error was received during the
firmware upgrade.
CABINET CONTROLLER UNABLE TO UPLOAD
Unable to upload firmware to the cabinet controller.
• Retry the download.
• Check cable connections.
• Replace Smart Media and retry.
ROBOTICS CONTROLLER UNABLE TO UPLOAD
Unable to upload firmware to the robotic controller. Verify that the
firmware image is correct and attempt to update again.
I2C BUS COMMUNICATION FAILURE
Unable to communicate with the drive cluster.
• Check I2C cable connection on the drive cluster.
• Check that the cluster is powered on.
• Check the LED status of the cluster controller.
o C (104 o F).
o C (120 o F).
115
HP StorageWorks