A Move Command Failed; A Flash Memory Error Is Reported; A Maximum Temperature Exceeded Warning Is Displayed; Switch Problems - HP StorageWorks ESL E-Series User Manual

• Verify that the designated cartridge is present and properly seated. (For a tape drive, make sure
the cartridge is completely unloaded.) Then, retry the command.
• Perform an inventory.
• If the error persists, contact a field service engineer.

A move command failed

• Check the source and destination. The source should hold the cartridge to be moved; the
destination should be empty.
• Make sure the picker is empty and that there are no obstructions.
• Also, make sure the library is on-line and the Stop button is released.
• Retry the command.
A flash memory error is reported
Contact your service provider

A maximum temperature exceeded warning is displayed

• Turn off the library and allow it to cool down. Lower the room temperature, if possible, and
increase ventilation around the library.
The air filters may need to be changed.
•
• If the operating temperature is too high, the library automatically shuts down until the temperature
drops.

Switch problems

1
2
Figure 52 LEDs on the switch for the internal network
Table 12 describes the meaning of the status indicator LEDs for the switch for the internal network.
76
Maintenance and troubleshooting
3
4
11653