Casio 3452 Operation Manual page 40

Changing to a Different
Phone Model
Q1
Connecting the current watch to
another phone.
Pair the watch with the phone.
After Purchasing Another Phone
l
Auto Time Adjustment by
Bluetooth Connection (Time
Adjustment)
Q1
When does the watch adjust is time?
The watch will connect with the phone and
perform auto time adjustment at around 12:30
a.m., 6:30 a.m., 12:30 p.m. and 6:30 p.m. The
connection is automatically terminated after
auto time adjustment is complete. Also, GPS
signal auto receive will be performed if there
has been no auto time adjustment based on
connection between the watch and phone for
more than one day.
Q2
Auto time adjustment is performed,
but the time setting is not correct.
Is auto time adjustment not being
performed according to its normal
schedule?
Note that auto time adjustment is not
performed for 24 hours after the time
setting is adjusted manually on the watch.
Auto time adjustment will resume after 24
hours.
Is a timer countdown operation in
progress?
Auto time adjustment will not start at the
scheduled times if a timer countdown
operation is in progress. Stop the timer
countdown operation.
Using the Timer
l
Is the watch in the Airplane Mode?
Auto time adjustment will not be
performed at the scheduled times if the
watch is in the Airplane Mode. Exit the
watch's Airplane Mode.
Using the Watch in a Medical Facility or
l
Aircraft
Operation Guide 3452
Q3
The watch does not synchronize its
time setting with a phone even
though I follow the steps under
Triggering Immediate Time
Adjustment.
The watch will not start time adjustment while
a timer countdown operation is in progress.
Wait until the timer countdown operation is
complete and then perform the operation
again.
Q4
Time is not displayed correctly.
The phone's time setting may be incorrect
because it is unable to connect with its
network due to being out of range, etc. If this
happens, connect the phone to its network
and then adjust the time setting.
Navigation
Q1
The watch won't enter the GPS
Navigation Mode.
Is the watch being charged with the
charger?
The GPS Navigation Mode cannot be
used while the watch is being charged
with the charger. Remove the watch from
the charger.
Is the battery charge level sufficient?
The GPS function can be used only when
the battery indicator shows
If the battery charge level is too low,
charge the watch.
Charging the Watch
l
Altitude Measurement
Q1
Readings produce different results at
the same location.
Watch readings are different from
altitude information available from
other sources.
Correct altitude readings are not
possible.
Relative altitude is calculated based on
changes in barometric pressure measured by
the watch's pressure sensor. This means that
barometric pressure changes can cause
readings taken at the same location to be
different. Also note that the value displayed by
the watch may be different from the actual
elevation and/or sea level elevation indicated
for the area where you are located. When
using the watch's altimeter while mountain
climbing, it is recommended that you regularly
calibrate its readings in accordance with local
altitude (elevation) indications.
Calibrating Altitude Readings
l
Q2
[-----] appears on the display
following altitude differential
measurement.
[-----] appears when the altitude differential is
outside the allowable measuring range
(±3,000 m). If [ERROR] appears on the
display, there may be a problem with the
sensor.
Setting a Reference Altitude and Taking
l
Relative Altitude Readings
or higher.
Q3
[ERROR] appears during
measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERROR]
keeps appearing after multiple measurement
attempts, contact a CASIO service center.
40