Casio 3452 Operation Manual page 34

To configure alarm settings
●
1.
Press (A).
This displays the Timekeeping Mode
setting screen.
2.
Rotate the rotary switch to move the
pointer to [ALARM].
3.
Press the rotary switch.
4.
Rotate the rotary switch to move the
pointer to the alarm whose setting you
want to change.
5.
Press the rotary switch.
6.
Rotate the rotary switch to change the
hour setting.
To cancel an alarm time setting,
●
perform the steps below.
A Press (C).
B Rotate the rotary switch to select
whether or not you want to save the
current settings.
[YES]: Current settings saved
[NO]: Current settings not saved.
C Press the rotary switch.
7.
Press (D).
8.
Rotate the rotary switch to change the
minute setting.
9.
Press (D).
10.
Rotate the rotary switch to turn snooze on
or off.
11.
Press the rotary switch.
This turns on the alarm whose time setting
you configured.
Turning on an alarm causes
●
appear on the display to the right of the
time setting. If snooze is turned on,
[SNZ] also appears.
12.
Press (C) as many times as necessary to
exit the setting screen.
Operation Guide 3452
To turn an alarm on or off
●
1.
Press (A).
This displays the Timekeeping Mode
setting screen.
Rotary Switch
2.
Rotate the rotary switch to move the
pointer to [ALARM].
3.
Press the rotary switch.
4.
Rotate the rotary switch to move the
pointer to the alarm whose setting you
want to change.
5.
Press (D) to the alarm where the pointer is
located between on and off.
Turning on an alarm causes
on the display to the right of the time
setting. If snooze is turned on, [SNZ] also
appears.
6.
Press (C) as many times as necessary to
exit the setting screen.
To stop a sounding alarm
●
Pressing any button while the beeper is
sounding stops it.
Note
When snooze is enabled for an alarm,
●
it will repeat every five minutes, up to
seven times. To stop an alarm's
ongoing snooze operation, turn off the
alarm.
The alarm beeper sound may be
●
distorted if a navigation operation is in
progress.
to
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Press (A).
This displays the Timekeeping Mode
setting screen.
Rotary Switch
2.
Rotate the rotary switch to move the
pointer to [BEEP].
3.
Press the rotary switch.
4.
Rotate the rotary switch to move the
pointer to [ON] (enabled) or [OFF]
to appear
(disabled).
5.
Press the rotary switch to exit the setting
screen.
This returns to the Timekeeping Mode
setting screen.
is displayed in the Timekeeping
●
Mode while the operation tone is
disabled.
6.
Press (C) to exit the setting screen.
Rotary Switch
34