Measure/Supply Volts Or Mv; Measure/Supply Hz Or Pulses; Rtd/Ohms Connections - GE Druck DPI 880 User Manual

Operation - Measure/supply Volts or mV
To measure/supply Volts or mV:
1. Connect the instrument (Figure 4/5) and, if necessary,
adjust the Set Up (Table 1).
2. Select the task from the task selection menu
(Table 2/3).
Note: Use the Dual Function area (
at the same time. If the area
set this area to off (■). This saves the battery power.
3. If necessary, adjust the Settings (Table 4/5) and/or the
output values to the system (Table 7).
Figure 4: Example configuration - To measure/supply Volts
or mV (Area
0 to ±30V
Figure 5: Example configuration - To measure Volts (Dual
Function, area
8
- [EN] English
➁ ) to do two operations
➁ selection is not necessary,
0 to ±30V OR 0 to 12V OR
0 to ±120mV 0 to 120mV
Edit
b) Supply
a) Measure
➀ )
➁ )
Operation - Measure/supply Hz or pulses
To measure/supply Hz or pulses:
1. Connect the instrument (Figure 6) and, if necessary,
adjust the Set Up (Table 1).
2. Select the task from the task selection menu (Table 2):
3. If necessary, adjust the Settings (Table 4/5) and/or the
output values to the system (Table 7).
Figure 6: Example configuration - To measure/supply Hz
For an input, the display shows the condition of the
frequency gate:
Settings
Gate open (measurement starts)
=
= Gate closed (measurement is waiting for the next
rising edge of the cycle)
Fast cycle
=
Operation - RTD/Ohms connections
In the examples that follow 2W, 3W, and 4W identify the 2,
3, and 4-wire connections for a RTD or resistance.
Settings Edit
a) Input b) Output
or Pulses
K405 Issue 3
Settings