Operation; Operation - Electrical Connections; Operation - Communications Port Connections; Operation - Measure Mv Or Volts - GE Druck DPI 832 User Manual

Operation

This section gives examples of how to connect and use the
instrument. Before you start:
• Read and understand the "Safety" section.
• Do not use a damaged instrument.

Operation - Electrical connections

To prevent instrument errors, make sure that the electrical
connections (A1-item [10] and/or A2) are correct.

Operation - Communications port connections

Use the communications port (A1 - item [9]) to attach an
IDOS Universal Measurement Module (UMM).
When you attach the cable from a UMM (Figure 6/7), the
instrument automatically changes the menus to give you
all the applicable options (Table 2/3).

Operation - Measure mV or Volts

To measure mV or Volts:
1. Connect the instrument (Figure 1) and, if necessary,
adjust the Set Up (Table 1).
2. Select the Volts input task from Select Task (Table 2/3)
and select the necessary range (mV or Volts).
3. If necessary, adjust the Settings (Table 4).
Figure 1: Example configuration - To measure mV
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
6 - [EN] English FAX 781.665.0780 - TestEquipmentDepot.com
0 ... ±120mV
0 ... ±30V
Volts
mV
Volts
Settings
or Volts

Operation - Change the output values

When the output operation is set up (Table 5), use one of
these procedures to change the output values:
Table 7: Procedures to change the output
Output Procedure
Select Edit (
See the example below.
Select Start/Stop (
,
to make the step changes manually.
Select Start/Stop (
Example procedure ("Nudge" output):
Display:
1
mA output
Sk1 = Edit
Sk2 = Settings
Display:
5
mA output
2.000
) and/or use the
) or use the
).
Edit 2 3 Edit
+01.000
6
3.000
Increment = 1.000
(Table 5)
K393 Issue 1
buttons.
buttons
4