Cisco 2800 Series Manual page 87

IP Communication Solution for Group Applications Configuration Example
connection trunk 20481
!
!---Multicast side of the back-to-back T1 used for bridging VoIP to multicast connection
!---trunk points to the dial-peer that is used for streaming into multicast
!
voice-port 0/2/1:1
auto-cut-through
timeouts call-disconnect 3
connection trunk 20480
!
voice-port 0/2/1:2
auto-cut-through
timeouts call-disconnect 3
connection trunk 20481
!
!---Multicast side of the back-to-back T1 used for bridging VoIP to multicast connection
!---trunk points to the dial-peer that is used for streaming into multicast for local
!---conferencing. 2111 dialed from the network side is looped back to the other side of
!---the T1 that is connected to the multicast dial-peer to convert it into a multicast
!---stream. The 3-party mixing algorithm takes care of conferencing between the dialed
!---parties
!
voice-port 0/2/1:3
auto-cut-through
timeouts call-disconnect 3
connection trunk 21111
!
voice-port 0/2/1:4
auto-cut-through
timeouts call-disconnect 3
connection trunk 21111
!
voice-port 0/2/1:5
auto-cut-through
timeouts call-disconnect 3
connection trunk 21111
!
voice-port 0/2/1:6
auto-cut-through
timeouts call-disconnect 3
connection trunk 21111
voice-port 0/3/0
!
voice-port 0/3/1
!
voice-port 0/3/2
!
!---FXS ports tied to multicast Hoot and Holler
!
voice-port 0/3/3
!
!---Dial peers pointing toward the NM-CUE for auto attendant and voice mail
!
dial-peer voice 27749 voip
description Towards CUE-Auto-Attendant
destination-pattern 27749
session protocol sipv2
session target ipv4:10.1.152.242
dtmf-relay sip-notify
codec g711ulaw
no vad
!
dial-peer voice 27748 voip
description Towards CUE-Voice-Mail
Configure
OL-6574-01
11