Verifying Branch 2 Router - Cisco 2800 Series Manual

Verify
The following is an output example for the show crypto engine brief command, performed using the
configuration on the Branch 1 router:
Branch-1# show crypto engine brief

Verifying Branch 2 Router

The following is an output example for the show crypto isakmp sa command, performed using the
configuration on the Branch 2 router (serial):
Branch-2# show crypto isakmp sa
dst
10.32.152.26
The following is an output example for the show crypto ipsec sa command, performed using the
configuration on the Branch 2 router:
Branch-2# show crypto ipsec sa
interface: Tunnel0
OL-6573-01
34
41789 packets, 6646861 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Queueing
Flow Based Fair Queueing
Maximum Number of Hashed Queues 256
(total queued/total drops/no-buffer drops) 0/0/0
crypto engine name:
crypto engine type:
State:
VPN Module in slot:
Product Name:
Software Serial #:
Device ID:
Vendor ID:
Revision No:
VSK revision:
Boot version:
DPU version:
HSP version:
Time running:
Compression:
DES:
3 DES:
AES CBC:
AES CNTR:
Maximum buffer length:
Maximum DH index:
Maximum SA index:
Maximum Flow index:
Maximum RSA key size:
crypto engine name:
crypto engine type:
serial number:
crypto engine state:
crypto engine in slot:
src
10.32.150.46
Crypto map tag: INT_CM, local addr. 10.32.150.46
Virtual Private Network (VPN) Module
hardware
Enabled
0
AIM-VPN/BPII
55AA
0014 - revision 0002
13A3
0x00140002
0
255
0
2.2(21) (ALPHA)
0 Seconds
Yes
Yes
Yes
Yes (128,192,256)
No
4096
1000
1000
2000
2048
Cisco VPN Software Implementation
software
70107010
installed
N/A
state conn-id slot
QM_IDLE
Hoot and Holler over V3PN Configuration Example
3 0