Cisco 2800 Series Manual page 152

Configure
qos pre-classify
tunnel source 10.32.153.34
tunnel destination 10.32.152.26
crypto map INT_CM
!
! VIF INTERFACE FOR MULTICAST SOURCE ADDRESS (USED FOR VOICE MULTICAST)
!
interface Vif1
ip address 192.168.7.1 255.255.255.0
ip pim sparse-dense-mode
!
interface FastEthernet0/0
description === Private interface ===
ip address 192.168.2.1 255.255.255.0
ip pim sparse-dense-mode
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
! DSL INTERFACE CONNECTING TO THE PUBLIC NETWORK IN OUR SCENARIO
! ATM PVC 8/35 IS USED IN THIS EXAMPLE.
!
interface ATM2/0
no ip address
no atm ilmi-keepalive
dsl equipment-type CPE
dsl operating-mode GSHDSL symmetric annex A
dsl linerate AUTO
pvc 0/35
encapsulation aal5snap
!
pvc 8/35
vbr-nrt 2000 1000
encapsulation aal5mux ppp Virtual-Template1
!
!
interface FastEthernet4/0
no ip address
!
interface FastEthernet4/1
no ip address
!
interface FastEthernet4/2
no ip address
!
interface FastEthernet4/3
no ip address
!
! LOGICAL INTERFACE FOR DSL LINK. THE PREVIOUSLY DEFINED LLQ QOS POLICY IS USED HERE
! PPP MULTILINK IS ENABLED SO INTERFACE CAN SUPPORT QOS
!
interface Virtual-Template1
description === Public interface ===
ip address 10.32.153.34 255.255.255.252
service-policy output LLQ
ppp multilink
ppp multilink fragment delay 8
ppp multilink interleave
crypto map INT_CM
OL-6573-01
12
Hoot and Holler over V3PN Configuration Example