Cisco 2800 Series Manual page 164

Verify
The following is an output example for the show ip route command, performed using the configuration
on the Headquarters router:
HUB-R1# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
Gateway of last resort is 10.32.152.25 to network 0.0.0.0
192.168.4.0/32 is subnetted, 1 subnets
C
O 192.168.5.0/24 [110/11] via 192.168.3.1, 00:12:48, Tunnel0
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C
C 192.168.6.0/24 is directly connected, Vif1
O 192.168.7.0/24 [110/11] via 192.168.2.1, 00:12:48, Tunnel1
C 192.168.1.0/24 is directly connected, Vlan10
O 192.168.2.0/24 [110/11] via 192.168.2.1, 00:12:50, Tunnel1
O 192.168.3.0/24 [110/11] via 192.168.3.1, 00:12:50, Tunnel0
S* 0.0.0.0/0 [1/0] via 10.32.152.25
The following is an output example for the show ip pim neighbors command, performed using the
configuration on the Headquarters router:
HUB-R1# show ip pim neighbor
PIM Neighbor Table
Neighbor
Address
192.168.3.1
192.168.2.1
The following is an output example for the show ip pim rp map command, performed using the
configuration on the Headquarters router:
HUB-R1# show ip pim rp map
PIM Group-to-RP Mappings
This system is an RP (Auto-RP)
This system is an RP-mapping agent (Loopback100)
Group(s) 224.0.0.0/4
RP 192.168.4.1 (?), v2v1
Info source: 192.168.4.1 (?), elected via Auto-RP
The following is an output example for the show ip mroute active command, performed using the
configuration on the Headquarters router:
HUB-R1# show ip mroute active
Active IP Multicast Sources - sending >= 4 kbps
Group: 239.168.1.100, (?)
Source: 192.168.5.2 (?)
Rate: 0 pps/0 kbps(1sec), 0 kbps(last 0 secs), 2 kbps(life avg)
Source: 192.168.7.2 (?)
Rate: 0 pps/0 kbps(1sec), 80 kbps(last 40 secs), 2 kbps(life avg)
OL-6573-01
24
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
192.168.4.1 is directly connected, Loopback100
10.32.152.24/30 is directly connected, ATM1/0
Interface
Tunnel0
Tunnel1
Uptime: 2d02h, expires: 00:02:25
Hoot and Holler over V3PN Configuration Example
Uptime/Expires Ver
00:13:52/00:01:40 v2
00:13:44/00:01:18 v2
DR
Prio/Mode
1 / S
1 / S