Programming; Preparation - Triax CGMM 480 Assembly Manual

5 p
r o g r a m m i n g
5.1 p
r e pa r at i o n
• Connect the test receiver to the RF output on the modulator module.
• Adjust the test receiver to the output channel of the channel strip to be set.
• Switch on the modulator if necessary. For each modulator, there is a green
LED which indicates if the modulator is switched on.
To use the CGMM 480 OIRT module the head-end station CSE 2800 must be set
to OIRT operation mode.
Therefore in the setup menu of the control unit
• press the
• Switch to standard "PAL DK" using the
• Press the
• Store the setting using the
To operate the CGMM 480 OIRT module the software version of the control unit
(head-end station) must be "V 9" or higher.
button twice.
—> The "Setting the Standard" - "NORM" menu is activated.
button.
—> The "Saving Data" - "MEMORY" menu is activated.
—> Always all modulator modules are set.
Mixed operation is not possible!
LED – Channel strip "A"
LED – Channel strip "B"
LED – Channel strip "C"
LED – Channel strip "D"
button.
button.
- 9 - CGMM 480 / CGMS 480