Carrier 30RBM 160 Installation, Operation And Maintenance Instructions page 51

12.2.4.2 - Installation and operation of the heat recovery with desuperheater option
Units with the desuperheater option are delivered with a plate heat exchanger for each refrigerating circuit.
When installing the unit, the heat recovery plate heat exchangers must be insulated and protected against frost if required.
Refer to the main diagram below for the main components or functions associated with a unit with desuperheater option in a
standard system.
Typical installation diagram of units with the desuperheater option
&
Legend
30RBM/30RBP unit components
1 Evaporator
2 Compressor
3 Desuperheater (plate heat exchanger)
4 Air condenser (coils)
5 Expansion valve (EXV)
6 Damage limitation accessory in case of a fire (safety valve)
7 Electric heater to protect the desuperheater against frost (not supplied)
8 Desuperheater insulation (not supplied)
9 Unit control box
10 NA
11 Desuperheater water inlet
12 Desuperheater water outlet
13 Evaporator water inlet
14 Evaporator water outlet
15 Unit with desuperheater option without hydronic module
16 System heat load
17 Border between the 30RBM/30RBP unit and the typical installation
%
4
5
6
8
7
3
2
! $
@
y
w
t
t q
)
W
r
q
e
28
t
30RBM/30RBP unit with desuperheater option without hydronic module
Border between 30RBM/30RBP unit and the system
Typical installation
4
5
6
7
1
3
2
#
@
^
w
q
o
u
p
Q
Installation components (installation example)
20 Pump (hydronic circuit of the desuperheater loop)
21 Shut-off valve
22 Desuperheater water flow balancing and control valve
23 Damage limitation accessory in case of a fire (safety valve)
24 Expansion tank
25 Charge or drain valve
26 Air purge
27 Heat exchange coil or plate heat exchanger
28 Pressure gauge
29 Flow switch
30 Pump (sanitary hot water circuit)
31 Three-way valve + controller
32 Filter to protect the pump and the desuperheaters
33 District water supply
34 Sanitary hot water outlet
8
9
!
R
E
51