Keba KeContact P20 Installation Manual page 23

Schematic diagram
Installation on hollow walls
Installation
Mounting the charging station
►
Turn the hanger bolts into the anchors
until the thread still protrudes
approx. 2 cm ('x').
►
Use the shims [A] to compensate for any
unevenness and to ensure a water
drainage behind the device.
►
Position and mount the charging station
using the supplied washers and nuts.
[A]...shim
[B]...charging station housing
[C]...washer
[D]...nut
Installation on hollow walls
For installation on hollow walls, at least two
mounting screws must be secured to a support
element of the wall (see figure).
Special hollow-wall anchors must be used for
the other mounting screws.
When installing on hollow walls you must en-
sure that the bearing strength of the construc-
tion is sufficient.
23 / 48