Removing And Replacing The Pix 525 Chassis Cover; Removing The Chassis Cover - Cisco PIX 501 Hardware Installation Manual

Chapter 6 PIX 525
Step 5 If you are using Stateful Failover, use one of the following types of connections, that is appropriate for
your system, between the dedicated interfaces on the PIX Firewall units:
•
•
•
Caution Do not turn the power on until the units are connected and the primary unit is configured completely.
Step 6 Power the primary unit on first, then power on the secondary unit. Within a few seconds, the active unit
automatically downloads its configuration to the standby unit.
If the primary unit fails, the secondary unit automatically becomes active.

Removing and Replacing the PIX 525 Chassis Cover

This section describes how to remove and replace the chassis cover from PIX 525. This section includes
the following topics:
•
•

Removing the Chassis Cover

This section describes how to remove the PIX 525 chassis cover.
Removing the PIX Firewall case does not affect your Cisco warranty. Upgrading the PIX Firewall does
Note
not require any special tools and does not create any radio frequency leak.
Complete these steps to remove the chassis cover:
Step 1 Power off the PIX 525 and disconnect site power.
Note
Step 2 Place the PIX 525 so that the front panel is facing you. If you place the PIX 525 on a table, ensure that
you have clear access to all sides.
Step 3 Remove the four screws on the chassis cover. (See
78-15170-01
Cat 5 crossover cable directly connecting the primary unit to the secondary unit.
100BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch.
1000BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch.
Removing the Chassis Cover, page 6-9
Replacing the Chassis Cover, page 6-11
Note that the power switch is part of the power supply.
Removing and Replacing the PIX 525 Chassis Cover
Figure 6-8.)
Cisco PIX Firewall Hardware Installation Guide
6-9