Cisco PIX 501 Hardware Installation Manual page 59

Chapter 5 PIX 520
If you are not installing a four-port Ethernet circuit board, add the cables as shown in
Figure 5-7
Installing Interface Cables to the PIX 520
Complete these steps to install interface cables to the PIX 520:
Locate the serial cable. The serial cable assembly consists of a null modem cable with RJ-45 connectors,
Step 1
two separate DB-9 connectors, and a separate DB-25 connector as shown in
Install the serial cable between the PIX Firewall and your console computer.
Step 2
Figure 5-8
Connect one of the DB-9 serial connectors to the console connector on the front panel of the
Step 3
PIX Firewall.
Connect one end of the RJ-45 null modem cable to the DB-9 connector.
Step 4
If you are installing an AC voltage PIX Firewall, connect the PIX Firewall unit's power cord to the power
Step 5
connector on the rear panel of the unit, and to a power outlet.
78-15170-01
Up to Four Single-Port Interfaces in the PIX Firewall
Interface 3
Interface 2
Interface 1
Interface 0
PIX Firewall Serial Cable Assembly
PIX Firewall
console connector
DB-9-to-DB-25
serial cable
(null-modem)
C
O
N
S
O
L
E
Console
port (DB-9)
Cisco PIX Firewall Hardware Installation Guide
Installing the PIX 520
Figure 5-7.
Figure 5-8.
Computer serial port
DB-25 or DB-9
5-5