Chapter 4
PIX 515/515E
Vertical Mounting the PIX 515/515E
To mount the PIX 515/515E vertically, attach the brackets to the side of the unit and mount the unit
vertically as shown in
Figure 4-6
Installing the PIX 515/515E
Complete the following to install the PIX 515/515E:
Connect the cable as shown in
Step 1
as required by the serial port for your computer, and the other end is the RJ-45 connector.
Note
Connect the RJ-45 connector to the PIX 515/515E Console port and connect the other end to the serial
Step 2
port connector on your computer.
78-15170-01
Figure
4-6.
Installing the PIX 515/515E Vertically
Figure 4-7
Use the Console port to connect to a computer to enter configuration commands. Locate the
serial cable from the accessory kit. The serial cable assembly consists of a null modem cable
with RJ-45 connectors, and one DB-9 connector and a DB-25 connector.
so that you have either a DB-9 or DB-25 connector on one end
Cisco PIX Firewall Hardware Installation Guide
Installing the PIX 515/515E
4-5