Cisco PIX 501 Hardware Installation Manual page 99

Chapter 6 PIX 525
Step 8 Reinstall the remaining fan. Make sure you orient the fan so that the cables feed to the right (toward the
second fan). Route the cable over the fan before you reconnect it. When correctly assembled, the cables
appear as shown in
Step 9 Starting with the fan farthest away from the power supply, bend the cable clamps over wires and into
the gap between chassis and fan housing.
Figure 6-23 Correct Fan Cable Routing
78-15170-01
Figure 6-23.
Front panel
Installing a DC Power Supply
Sheet metal tabs
Base tabs
Cisco PIX Firewall Hardware Installation Guide
6-23