Advertisement
Removing and Replacing the PIX 506/506E Chassis Cover
Removing and Replacing the PIX 506/506E Chassis Cover
This section describes how to remove and replace the chassis cover from the PIX 506/506E. This section
includes the following topics:
•
•
Removing the Chassis Cover
Complete the following to remove the chassis cover:
Removing the chassis cover does not affect your Cisco warranty. Upgrading the PIX security appliance
Note
does not require any special tools and does not create any radio frequency leaks.
Read the Regulatory Compliance and Safety Information document.
Step 1
Power off the security appliance and unplug the power cord.
Step 2
Warning
Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Disconnect the network interface cables.
Step 3
Step 4
Remove the two screws from the back of the chassis (see
Figure 3-8
With the rear panel facing you, slide the chassis cover back and then lift it up off the bottom section, as
Step 5
shown in
Cisco PIX Security Appliance Hardware Installation Guide
3-6
Removing the Chassis Cover, page 3-6
Replacing the Chassis Cover, page 3-7
Removing PIX 506/506E Chassis Cover Screws
ACT
LINK
ACT
ETHE RNET 1
Figure
3-8.
DC
POWE R
INPUT
LINK
ETHE RNET 0
USB
CON SOLE
Chapter 3
Figure
3-8).
PIX 506/506E
78-15170-02
Advertisement
