Installing An Optional Module On The 4002-Y2B And 4002-Y4B; Installing An Optional Module - IBM 4002-Y2A Installation And User Manual

Installing an optional module on the 4002-Y2B and 4002-Y4B

Figure 29. Installing an optional module
The 4002-Y2B and 4002-Y4B switches support an optional two-port 10 Gbps
Ethernet XFP module. This module is hot-swappable / hot-installable, however a
reload command is required to recognize the new ports. It is recommended that
the device be powered off prior to installing this module.
Use the following procedure to install an optional module into the switch.
1. Power off the device by removing all power cords connected to the power
2. Remove the blank metal plate (or a previously installed module) from the slot
3. Before opening the package that contains the module, touch the bag to the
4. Remove the module from the antistatic shielded bag.
5. Holding the module level, guide it into the carrier rails on each side and gently
6. When you are sure the module has properly engaged the connector, tighten the
7. Power on the switch by plugging in the power cords into the power supplies.
Attention: If you do not install a module in a slot, you must keep the slot panel
in place. If you run the device with an uncovered slot, the system will overheat.
26
Ethernet y-series Installation and User Guide: Installation and User Guide
supplies.
by removing the two screws with a Phillips #2 screwdriver.
switch casing to discharge any potential static electricity. Using an ESD wrist
strap during installation is recommended.
push it all the way into the slot, ensuring that it firmly engages with the
connector.
retainer screws to secure the module in the slot.
When the switch is powered on, the LEDs will follow the LED status as
described in "Port, system, and power status LEDs for the 4002-Y2B and
4002-Y4B" on page 8.