Digital Optical Monitoring - IBM 4002-Y2A Installation And User Manual

Digital optical monitoring

You can configure your device to monitor optical transceivers in the system, either
globally or by specified port. When this feature is enabled, the system monitors the
temperature and signal power levels for the optical transceivers in the specified
ports. Console messages and syslog messages are sent when optical operating
conditions fall below or rise above the XFP, SFP, and SFP+ manufacturer's
recommended thresholds. For more information about digital optical monitoring,
refer to FastIron Configuration Guide.
42
Ethernet y-series Installation and User Guide: Installation and User Guide
Table 21. Cable statistics (continued)
This Line... Displays...
Local pair The local link name.
Pair Length The cable length when terminated, or the distance to the point of fault
when the line is not up.
Remote pair The remote link name.
Pair status The status of the link. This field displays one of the following:
v Terminated: The link is up.
v Shorted: A short is detected in the cable.
v Open: An opening is detected in the cable.
v ImpedMis: The impedance is mismatched.
v Failed: The TDR test failed.