Installing A Transceiver; Supported Sfp Transceivers For 4002-Y2A, Y4A, Y2C, And Y4C - IBM 4002-Y2A Installation And User Manual

Note: Distances supported on -SR optics depends on type of multi-mode fiber

Installing a transceiver

You can install a new transceiver in an XFP, SFP, or SFP+ slot while the device is
powered on and running.
While installing a transceiver, wear an ESD wrist strap with a plug for connection
to a metal surface.
Note: For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
Use the following steps to install a transceiver.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a
2. Remove the new transceiver from the protective packaging.
3. Gently insert the transceiver into the slot until it clicks into place. Transceivers
36
Ethernet y-series Installation and User Guide: Installation and User Guide
Table 18. Supported XFP transceivers for 4002-Y2B and 4002-Y4B (continued)
10 Gigabit Optic
10GBase-ER
Table 19. Supported SFP transceivers for 4002-Y2A, Y4A, Y2C, and Y4C
10 Gigabit Optic
10GSFPP-SR
10GSFPP-LR
cabling used. OM3, 50 micometer (2000 MHz*km) fiber is required to
support maximum distances.
resistor.
CAUTION:
Data processing environments can contain equipment transmitting on
system links with laser modules that operate at greater than Class 1
power levels. For this reason, never look into the end of an optical fiber
cable or open receptacle. (C027)
metal surface (such as an equipment rack) to act as ground.
are keyed to prevent incorrect insertion.
Distance Supported for stacking
40km No
Distance Supported for stacking
300km Yes
10km No