Before Installing The Switch Module - IBM EN4093R User Manual

v I/O bays 3 and 4 support any standard IBM Flex System switch or pass-thru
v The compute nodes or IBM Flex System chassis that are described or shown in
v When the switch is installed in a IBM Flex System chassis, the internal ports

Before installing the switch module

Locate and record information about the switch module in the following table. The
labels contain the product name, model number, serial number, part number and
the media access control (MAC) address for the switch module. After the switch
module is installed most of the labels are hidden from view (located on the bottom
and rear of the module) and require removing the switch module in order to relocate
them.
Figure 1. Locating labels
Record this information below and print this page and keep it in a safe place for
possible future reference. You will need this information when you register the
switch module with IBM. You can register the switch at http://www.ibm.com/support/
mysupport/.
4
EN4093 and EN4093R 10 Gb Scalable Switch: User's Guide
module. When you install an I/O network adapter in the right fabric connector on
the compute node, these I/O bays support any switch with the same type of
network interface that is used by the corresponding network adapter.
this document might be different from your compute node or IBM Flex System
chassis. For additional information, see the documentation that comes with your
IBM Flex System chassis.
operate at 1 Gbps or 10 Gbps. The external ports can operate at 1 Gbps or 10
Gbps, depending on the SFP module type.