Upgrading Firmware
2.13 Upgrading Firmware
Periodic upgrades to the firmware of the FPGA, DLPC300, MSP430, and EDID are accomplished through
the DLP LightCrafter GUI. To upgrade the DM365 firmware, a micro-SD card with the new software is
needed to load the software into the NAND flash.
2.13.1 Updating the MSP430, FPGA, DLPC300, or EDID using the GUI
To upgrade the FPGA, DLPC300, MSP430, or EDID, perform the following steps:
1. Select the "Solution / Splash" and "Firmware Upgrades" tabs as shown in
48
Operating the DLP LightCrafter
Figure 2-54. DLP LightCrafter GUI Camera Tab
Copyright © 2012–2013, Texas Instruments Incorporated
Figure
2-55.
DLPU006C – January 2012 – Revised December 2013
Submit Documentation Feedback
www.ti.com