Video Tampering; Network Settings - Honeywell HEIPTZ-2201W-IR User Manual

Video Tampering

Network High Speed Dome "Video Tampering" setting interface as figure 4-18
 Enable: Set whether open the video tempering
 Alarm Schedule: Set the alarm schedule from Monday to Sunday.
 Drawing: Click Drawing, then set the video tampering area.
 Clear: Click Clear to clear the current video tampering areas.
 Sensitivity: The higher of the sensitivity, the obvious of the video tampering effect.
 Email: Send Email to appointed mailbox when alarm triggered.
 Snap: Snapshot and install the picture in the HDD when alarm triggered.
 Record: Video record and installed in the HDD or send as FTP to keep when alarm triggered.
 Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch
to make alarm output.
 Enable PTZ: Alarm input to link the PTZ motion.
 Preset: Alarm input to link the preset.
 Snap Interval: Set the snapshot interval time
 Snap Count: Set the snapshot count in every second
After all parameters setting completed, click "Save" and the it comes into effect immediately.

Network Settings

Network High Speed Dome "Network Settings" interface as figure 4-19.
Figure 4-18
Honeywell
27