Honeywell HEIPTZ-2201W-IR User Manual page 25

Operation
 Alarm Info: Warns light flashing when camera device inform alarm. Support kinds of alarms record, and
setup or remove the alarm setting,clear the alarm information.
 Zoom-in: Use the mouse to do local zoom for the video display area by scrolling the mouse wheel.
 PTZ control: Up/ down/ left/ right/ auto/ adjust the PTZ rotate speed, etc. As figure 4-9.
 Lens control: Do scaling, focus, iris operation, as figure 4-9.
 Brightness: Adjust the image brightness. As figure 4-10.
 Contrast: Adjust the image contrast. As figure 4-10.
 Cyclotron arrow: Restore the default parameters. As figure 4-10.
 PTZ setting: preset setting, cruise, track setting, linear scan, idle ope , IR light, wiper, spray setting.As figure
4-11.
Preset setting: Adjust the camera to the appointed angle and location through directional buttons,
and then select a preset number on the preset drop down list, click
Call preset: Select a preset number which needed to call on the preset drop down list, then click
it.
Cruise: 255 presets addable, stay time 1-255s adjustable, cruise speed 1-7 levels selectable. All
cruise tracking can be call and delete independently.
Tracking path setting: Select a number at the tracking drop down list, click
operation, then click
Call tracking path: Select a number at the tracking drop down list, click
Linear: Select a number at the linear drop down list, click
do a serious PTZ operation, then click
Linear scan only supported horizonal scan, and the vertical angle depend on the final position, linear
path is two point minimum path
Call linear: Select a number at the linear drop down list, click
Idle ope : Idle ope include preset setting, cruise scan, tracking, swing scan. Click
and the idle time is 1-15 min selectable, click
verify whether the idle ope setting completed. When set idle ope successfully, speed dome camera will
do idle ope operation after the setted idle time
IR light: Auto/ Manual selectable, when select Auto, it will turn on the IR led according to the zoom
module multiples, near open for 1X, middle-open for 2-4X, far open for 5X or 5X later. When select
Manual, there All close/ near open/ middle open/ near middle open/ far open/ far near open/ middle far
open/ all open totally 8 kind of choices
Wiper: Open or close wiper function.
18
Clear cruise: Click to clear all cruise scan setting
Call cruise: Click to call setted cruise scan
to save and exit the tracking path setting.
to set the linear scan initial position, and
to save and exit the linear scan setting.
to call linear scan
to save the idle ope setting, click
to set it.
, and do a serious PTZ
to call tracking path
to set idle ope,
to call
to