Advertisement
MAINTENANCE
WARNING :
TO AVOID ELECTRICAL SHOCK REMOVE TEST LEAD BEFORE OPENING THE COVER.
4-1 General Maintenance
1. Repairs or servicing not covered in this manual should only be performed by qualified personal.
2. Periodically wipe the case with a dry cloth and detergent do not use abrasives or solvents.
4-2 Battery Installation or Replacement
The meter is powered by 9V battery. Refer to Figure 2 and use the following procedure to replace the battery:
1. Disconnect the test leads and turn the meter off. Remove the test leads from the front terminals.
2. Position the meter face down. Remove the screw from the battery cover.
3. Lift the end of the battery cover until it gently unsnaps from the case bottom.
4. Lift the battery from the battery compartment and carefully disconnect the battery connector leads.
5. Snap the battery connector leads to the terminals of a new battery and reinsert the battery into the battery
compartment.
6. Replace the battery cover. Make sure that the battery leads do not become pinched between the case bottom
and case top.
29
Advertisement
