Maintenance - Iso-Tech ICM 136R Instruction Manual

Caution
If the clamp-multimeter is used in the vicinity
of equipment which generates electromag-
netic interference, the display may become
unstable or the measurements shown may
be subject to large errors.
TEST EQUIPMENT RISK ASSESSMENT
Users of this equipment and or their
employers are reminded that Health and
Safety Legislation require them to carry
out valid risk assessments of all
electrical work so as to identify potential
sources of electrical danger and risk of
electrical injury such as from inadvertent
short circuits. Where the assessments
show that the risk is significant then the
use of fused test leads constructed in
accordance with HSE guidance note
GS38 " Electrical Test Equipment for use
by Electricians" should be used.

Maintenance

Do not attempt to repair the clamp-
multimeter. It contains no user-serviceable
parts.
Contact RS Components for repair,
servicing or calibration of this clamp-
multimeter. The address is given at the
end of these instructions.
Cleaning
To clean the clamp-multimeter, use a
damp cloth moistened with a weak
detergent solution. Do not use abrasives
or solvents.
3