Is The Paper Size Loaded To The Bypass Tray Same With The Paper Size Being Displayed In The Touch Panel - Sharp MX-B455W Troubleshooting Manual

General Problems
THE DISPLAYED BYPASS TRAY PAPER SIZE IS
?
NOT CORRECT
Check
Is the paper size loaded to the bypass
tray same with the paper size being
displayed in the touch panel?
THE ORIGINAL MISFEEDS (AUTOMATIC DOCUMENT
?
FEEDER)
Check
Is too much paper loaded into the
document feeder tray?
Is the original a long original?
Is the original on thin paper?
Is the feed roller dirty?
!
Solution
■ Set the "Tray Settings" setting on the home screen and change to the paper size
loaded with the paper size setting of the bypass tray.
!
Solution
■ Make sure that the stack of paper in the tray is not higher than the indicator line.
► Placing the original and adding paper (page 5)
■ When using the automatic document feeder to scan a long original, set the scan
size to [Long Size].
(Note that long originals cannot be copied using the copy function.)
■ Use the document glass to scan the original.
If you need to use the automatic document feeder, use [Slow Scan Mode] in
[Others] to scan the original.
*The MX-B355W cannot scan thin paper using the automatic document feeder.
■ Clean the surface of the paper feed roller.
► Maintenance (page 6)
11