Is Too Much Paper Loaded Into The Bypass Tray - Sharp MX-B455W Troubleshooting Manual

General Problems
THE IMAGE IS SKEWED ON THE PAPER
?
Check
Is too much paper loaded into the
bypass tray?
Are the bypass tray guides adjusted
to the width of the paper?
Are the original guides adjusted to the
width of the paper?
LINES APPEAR IN THE SCANNED IMAGE
?
Check
Are the scanning areas of the
document glass or automatic
document feeder dirty?
SMUDGES APPEAR ON PRINTED OUTPUT
?
Check
Are you using paper that is not within
the specifications?
Are you printing on pre-punched
paper?
Does a message appear indicating the
need for maintenance?
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
!
Solution
■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
The maximum number of sheets varies depending on the paper type setting.
■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
■ Adjust the original guides to the width of the paper.
!
Solution
■ Clean the scanning areas of the document glass or automatic document feeder.
► Maintenance (page 6)
!
Solution
■ Use SHARP-recommended paper.
Using paper that is for other models or special paper that is not supported may
result in misfeeds, creases, or smudges.
 - "SUPPLIES" in Start Guide
■ Take care that the image does not overlap the punch holes.
If the printed image overlaps the punch holes, smudges may appear on the
reverse side of the paper following 1-sided printing, or on both sides following
2-sided printing.
■ Contact your dealer or nearest SHARP Service Department as soon as possible.
■ This may improve some states of paper curling.
► Placing the original and adding paper (page 5)
14