Furuno FCV-2100 Operator's Manual page 5

CAUTION CAUTION
Do not use depth information for
navigation while the picture advance
speed is set to "stop".
The depth indication is not refreshed
while the picture is stopped. Use of
depth data for navigation in this case
could lead to grounding or other
dangerous situation.
Do not transmit with the transducer
out of water.
The transducer will be damaged.
Keep the following points in mind
regarding cables.
• Keep the cables away from lubricants
and fuels.
• Avoid areas where the cable may be
damaged.
• Do not paint the cables.
Solvents such as toluene, contained
in paints, can damage the cable's
protective covering.
• Do not cut the cables.
The cables may be damaged or
become corroded.
• Do not carry the equipment using only
the cables.
The cables may be damaged or
become disconnected.
CAUTION CAUTION
Adjust the gain properly.
Too little gain may present no picture.
Too much gain shows excessive noise
on the picture.
Keep the bottom echo and depth
indication shown stably.
Unstable bottom echo and depth
indication can result in grounding if the
vessel is steered acoording to the
informations on the display. If unstable,
adjust the setting of [Bottom Level] or
[TX Power].
Do not connect/disconnect the
cables connected to the processor
unit while turning the power on.
The unit may be damaged.
Warning Label
A warning label is attached to the Transceiver
Unit. Do not remove the label. If the label is
missing or illegiblem contact your local dealer
regarding a replacement.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
SAFETY INSTRUCTIONS
Name: Warning Label (1)
Type: 86-003-1011-3
Code No.: 100-236-233-10
iii