INSTALLATION OF THE DECORATION PANEL
Detach the intake grille.
Slide the 2 grille hooks toward the middle of the decoration
- Open the intake grille at the angle shown below and remove it.
Install the Decoration Panel
- Align the indicated " " on the decoration panel to the indicated
" " markings on the unit
- Attach the decoration panel to the unit with the supplied screws
as shown in figure below.
- --<' - --- -
、 、 、 、--- -
Screws (MS)(supplied with the panel)
- After installing the decoration panel, ensure that there is no
space between the unit body and decoration panel. Otherwise,
air may leak through the gap and cause dewdrops.
(See figure below)
Mount the Intake Grille.
Ensure that the buckles at the back of the grille be properly
seated into the groove of the panel.
Connect the 2 wires of the decoration panel to the
mainboard of the unit.
Fasten the control box lid with 2 screws .