Software Communication And Control Issues; Pilot Lite Fails To Communicate With Installed Modules - Imagine communications Selenio 6800 Installation And Operation Manual

Software Communication and Control Issues

+

Pilot Lite Fails to Communicate with Installed Modules

HMX6800+BC8 Installation and Operation Manual
Appendix A: Communication and Control Troubleshooting Tips
• "+ Pilot Lite Fails to Communicate with Installed Modules" on
page 77
• "+ Pilot Lite Does Not Find All Modules in Frame" on page 78
• "+ Pilot Lite or CCS Software Application Not Responding" on
page 79
• "+ Pilot Lite Cannot Control a Module Showing
in the Control Window" on page 79
• "+ Pilot Lite Reports "Not Ready" Status" on page 79
• "CCS Software Application or Remote Control Panel Does Not
Communicate with Module" on page 80
• "Alarm Query Fails When a Device Reboots" on page 80
Confirm that the following items are not the reason for the
communication failure:
• Proper module slot has not been specified (+ Pilot Lite is not
communicating with the appropriate slot). See your FR6802+
Frame Installation and Operation Manual for more information on
slot identification.
• COM port is used elsewhere (Check that the correct COM port is
configured in + Pilot Lite and that another application is not using
that COM port).
• Actual frame ID does not match with the two DIP switch settings in
the back of the frame (+ Pilot Lite is not communicating with the
proper frame). See your FR6802+ Frame Installation and
Operation Manual for more information on frame ID switch
settings.
• Null modem cable is not being used. Between the PC running
+ Pilot Lite and the FR6802+ frame, there should be a null RS-232
modem cable. At minimum, this requires that pins 2 and 3 are
crossed and 5 to 5 for ground.
• ICE6800+ module is installed in the frame (+ Pilot Lite control is
disabled if an ICE6800+ module is installed in the frame;
ICE6800+ modules are used for CCS control).
77